World Leader in the Manufacture and Supply of Injection Molded Cable Management Products 513-201-3069

Mounting KDP-Multi Screw-on mounting

kdh_kdp_multi_mon_1_schraub
Create a cut-out and drill holes (112 x 36 mm) for the cable entry plate.
kdh_kdp_multi_mon_2_schraub_click
Lay the cable into an appropriate grommet and provide strain relief where necessary using cable ties.
kdh_kdp_multi_mon_4-09_schraub
Use appropriate tool to punch through cover on base frame.
kdh_kdp_multi_mon_5-09_schraub_click
Select a sleeve suitable for the diameter of the cable and place the cable in the sleeve. Make sure there is enough cable length. Close the sleeve and if necessary relieve strain on the cable using a cable tie. Position the sleeve in the cable entry system.
kdh_kdp_multi_mon_6-09_schraub_click
Select an opening appropriate for the cable diameter and push the cable through the opening from the front. The indicator becomes visible on the rear side. Pull cable through to desired length. Retract cable approx. 10 – 15 mm until the indicator on the rear is no longer visible. Depending on cable diameter and insertion size, the indicator may well become visible on the front side again.
kdh_kdp_multi_mon_7-09_schraub
Position and affix the cable entry plate above the cut-out.
kdh_kdp_multi_mon_8-09_schraub
Press down the cable entry system at the edges again.
Displaying Metric Units